Amahi Forums

Just voicing a bit of installation frustration.
After several attempts to install, blank screen before Language Selection screen.
Eventually got upto Installation Summary page, however Amahi Server Setup would not acknowledge my Installation Code.
Once Installation Code was accepted, a warning symbol was displayed on Installation Source. This eventually cleared after using a mobile phone as an internet hot spot (USB)
Installation then proceeded to the first re-boot. This ran over night eventually overheating all Cores and no second re-boot.
Anyone else having issues with 11 or am I just the lucky one???

Which install media are you using (i.e. Express CD, Minimal CD, or Full DVD)? Also are you using CD / DVD or USB? It sounds like you might be using the Express CD.

I have done several installs with Minimal CD with no issues. I did test the Express CD and had no problems, so not sure what's causing you problems.

Express CD. And minimal thru Troubleshooting.
Tried a few more times last night and same result. Tried USB, same result.
I'll install a fresh 10 tonight and try an upgrade one more time.
I've also downloaded the minimal iso, so I'll try that too.
If no success, I will stay with 10.

It may be the Express CD does not have the drivers needed for your system.

Recommend trying the Fedora 27 Minimal CD first. If that does not work, then try the Full DVD.

I anticipate you will have success with the Minimal CD.

Thanks Big, Minimal CD installed. Fedora crashed a few times, but found an issue with Fedora and my graphics card bios settings. Fix this and installed required apps.
When trying to use Disk Wizzard to mount my additional dard drives, the dashboard had an exception and crashed. I mounted them via the terminal with no issues.
This was a long winded process, but got there in the end. Thanks for your suggestions.

Awesome. Glad you got it sorted out.

By the way, there is a bug report for Disk Wizard. Refer to bug 2355.

Marking as resolved.