Amahi Forums

Hello,

I'm installing the Fedora 25/Amahi 10 per the installation instructions. When I get to the: dnf -y install hda-ctl command line it installs Fedora 25 - x86_64 (50MB) then installs Fedora 25 - x86_64 - Updates (24MB). the next line reads: Last Metadata expiration check: 0:00:20 ago on Todays date and time. Finally i get this line:

No package hda-ctl available.
Error: Unable to find a match.

Am i typing something incorrectly? How do i progress from here? i'm already registered and have my install code ready!

Thanks,
Nash

Try the following before executing that command:

Thanks for the quick response!

But, I get the same error after running:
sudo dnf clean all

What version of Fedora did you install?

Are you getting network connectivity?

I presume you followed guidance at http://docs.amahi.org.

Yes i have been following installation guide you referenced. I've installed Fedora 25 and yes i believe i am getting network connectivity in the Fedora set up. i have 2 network ports on this motherboard so i manually assigned the ip address. May this be causing the issue?

i do have network connection. i was able to ping successfully.

i have 2 network ports on this motherboard so i manually assigned the ip address. May this be causing the issue?

Yes, that is the issue. The system requirements are specific. ONLY one network interface can be enabled when installing Amahi.

You will have to start over with the Fedora 25 install after disabling one network card.

Just to note, i have successfully installed amahi on Fedora 14 on this pc prior to upgrading today. i assume i will need to disable my nvidia ethernet controller in the bios. Thanks for the input i will give it another try.

Let us know how it goes.

Will mark this thread as closed.

That did the trick. You can close this thread. Thanks!