Page 1 of 1
Amahi 10 status not showing up in control panel
Posted: Sun May 14, 2017 8:23 am
by amielgoldberg
I've installed Amahi 10 as recommended in the installation instructions. The server has been up for at least 24 hours. So far the Amahi Control Panel still shows the status as Not Updating. Please let me know how I can help troubleshoot this issue. I haven't found anything in the wiki or forums that addresses this issue in Amahi 10.
Re: Amahi 10 status not showing up in control panel
Posted: Sun May 14, 2017 9:14 am
by myvault
Hello,
Are you able to access the server through another computer on the local network ?
Re: Amahi 10 status not showing up in control panel
Posted: Sun May 14, 2017 10:26 am
by bigfoot65
It sometimes takes a while for the status to changes on amahi.org site.
Did you reuse a previous HDA profile or create a new one? Does all the info match your network configuration?
Again, need details.
Re: Amahi 10 status not showing up in control panel
Posted: Wed May 17, 2017 8:01 pm
by amielgoldberg
Apologize for the slow response. I'm traveling for business right now, so I've only now gotten to check my personal email, etc.
Yes, I can see it from other computers on the network but can't install new applications. Also, the status on the control panel now says stopped, but I believe the server is still up and running. Or at least it was when I left. As I mentioned, I'd turned on the router DHCP and DNS.
Appreciate any thoughts on next steps to troubleshoot.
Re: Amahi 10 status not showing up in control panel
Posted: Wed May 17, 2017 8:03 pm
by amielgoldberg
Yes, I reused a HDA profile, but completely wiped the machine and started fresh. Yes, the network configuration matches.
Re: Amahi 10 status not showing up in control panel
Posted: Thu May 18, 2017 6:23 am
by bigfoot65
You may need to reboot it a few times.
Also recommend you see the
Network Troubleshooting page.