Amahi Control Panel Will Not Accept My Correct Default Gateway

[Ryanshelley]

Hi,

I've been trying to obtain my install code from the control panel but I can't seem to get it to accept the correct default gateway.

According to my ipconfig check on Windows, my default gateway is 192.168.0.1; however, the default provided on the control panel is 192.168.1.1. When I try to correct this, it will not allow me to move forward to Step 2.

Could someone please offer some advice as to how I might move forward?

[Ryanshelley]

My apologies. I just found the instructions for the non-default setup and am going to give that a try.

[bigfoot65]

Ok. You should be able to change the default gateway based on IP address you entered.

Has this been resolved?

[Ryanshelley]

Thanks for the reply. But now I have a different problem. This time, I can't seem to install Amahi 9. When I type in the command as listed in the instructions, I get the following : rpm: - y: unknown option.

Any ideas as to what I'm doing wrong here?

[bigfoot65]

When I type in the command as listed in the instructions, I get the following : rpm: - y: unknown option.

Copy one line at a time when doing this part. There is no command in the instructions that states rpm -y.

[Ryanshelley]

Thanks, bigfoot. That got me through the Amahi installation but after I rebooted the hda and all my devices, I still can't access http://hda or http://setup.

When I run the troubleshooter, it says my hda dns is not working for local hostnames.

And here's what I got from running the sysinfo command

http://paste.fedoraproject.org/376632/14654799/

[bigfoot65]

I still can't access http://hda or http://setup.

Try the following:

Code: Select all

hda-ctl-hup

You also may have to reboot afterward.

[Ryanshelley]

Sorry, I 'm brand new to Linux so, just to clarify, I need to type both of those lines separately into the terminal? Thanks for your patience.

[bigfoot65]

No just the command: hda-ctl-hup

When executing commands, it's best to do a single line at a time, then press ENTER.

Pretty much just like you would for Windows.

[Ryanshelley]

Ok, thanks. So I entered the command and it said it was restarting the hda. Then I rebooted the server and then rebooted the device I'm using to access the web but it says http://hda is still unavailable.