Amahi Forums

Hello,

I tried installing Amahi (Fedora9-i386-DVD.iso) on my pc. Using the dvd i booted, followed the install instructions. Install completed. All i had left was to enter hda-install + code in a terminal but that command can't be found! (i logged in as ROOT!)
I also couldn't add sources during installation and tried to do so after the installation but i can't find where i should do that..
?

ps: after the installation my ip was 192.168.1.5 (instead off the 192.168.1.10 that i had registered in my control panel) I deleted that profile and made an new one, this time with the right ip) But i still can't "hda-install". I did however was able to run updates. Tried to get a vncserver going (which it did) but i can't get access remotely. ports in the firewall are forwared correctly (5900/5901/5902/5903) Vncpasswd for the user had been set.

ps: i used a dvd-drive to install Amahi, but removed it afterwards so that i can use 4 ide-harddisks in the pc in stead off just 3. I hope/guess that does not influence the systems performance.

Hope ik can fix all this because the pxe booting/backup option really sounds great to me!!!

Hi,

This is rather strange. did you add the http://f9.amahi.org repo during install?

The hda-install program should be installed if you did, and it should be in /usr/bin/hda-install

If not, and you rather not reinstall (which is what id' nominally recommend), you can try the procedure to install on an existing F9 system.

Hello!

Second time around the install worked!!!