Page 1 of 1
Fedora12 w/ Amahi install NOT Succeed! Can't get Amahi http
Posted: Sat Mar 13, 2010 11:05 am
by coolstone
Hey guys,
It's my very first to install fefora, and it's V12, for x86-64. I met network connection problem in my previous installation, so I tried a second time. But when I try to "enable your network interface", it gave me an error: "An error occurred trying tobring up the eth0 network interface.". I tried again and it just freezed there and won't work anymore.
I use Comcast cable service, and a Apple Exteme station as router with gateway "10.0.1.1". This desktop is new HP e9150t with Gigabit Network card. Don't know why.
Anyone can give me any hint?
Thanks!
coolstone
Re: Fedora12 w/ Amahi install NOT Succeed! Can't get Amahi http
Posted: Sat Mar 13, 2010 3:26 pm
by coolstone
I don't know if I can install Amahi after I install Fedora. Is there anyway I can get the install package?
Thanks!
Re: Fedora12 w/ Amahi install NOT Succeed! Can't get Amahi http
Posted: Sat Mar 13, 2010 5:44 pm
by coolstone
Maybe I just quit this complicated, time-costing system and go back to WHS....
Re: Fedora12 w/ Amahi install NOT Succeed! Can't get Amahi http
Posted: Sat Mar 13, 2010 8:28 pm
by cpg
Hi,
The Apple Extreme/Express is *extremely* hard to make it work as a bridge and with all the functionality that uses the most out of Amahi.
See the wiki page on
Airport Extreme/Express.
However, it seems like your system has some incompatibilities with Fedora 12 networking. Perhaps the hardware is not well supported in Fedora 12?
If you can post hard details, perhaps we can help you.
Re: Fedora12 w/ Amahi install NOT Succeed! Can't get Amahi http
Posted: Sat Mar 13, 2010 10:13 pm
by coolstone
Hey cpg,
Thanks a lot for your help!
I was able to have connection, but now I can't again,even I reinstall the system.
Here is the result of ifconfig:
****************************************
Code: Select all
[coolstone@fedora12 ~]$ ifconfig
eth0 Link encap:Ethernet HWaddr 00:26:18:3D:D7:14
inet addr:10.0.1.3 Bcast:10.0.1.255 Mask:255.255.255.0
inet6 addr: fe80::226:18ff:fe3d:d714/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:607 errors:441 dropped:0 overruns:0 frame:310
TX packets:434 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:63257 (61.7 KiB) TX bytes:45082 (44.0 KiB)
Memory:f9ec0000-f9ee0000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:8 errors:0 dropped:0 overruns:0 frame:0
TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:480 (480.0 b) TX bytes:480 (480.0 b)
********************************************
and /sbin/lspci:
********************************************
[root@fedora12 coolstone]# /sbin/lspci
00:00.0 Host bridge: Intel Corporation X58 I/O Hub to ESI Port (rev 13)
00:01.0 PCI bridge: Intel Corporation X58 I/O Hub PCI Express Root Port 1 (rev 13)
00:03.0 PCI bridge: Intel Corporation X58 I/O Hub PCI Express Root Port 3 (rev 13)
00:07.0 PCI bridge: Intel Corporation X58 I/O Hub PCI Express Root Port 7 (rev 13)
00:14.0 PIC: Intel Corporation X58 I/O Hub System Management Registers (rev 13)
00:14.1 PIC: Intel Corporation X58 I/O Hub GPIO and Scratch Pad Registers (rev 13)
00:14.2 PIC: Intel Corporation X58 I/O Hub Control Status and RAS Registers (rev 13)
00:14.3 PIC: Intel Corporation X58 I/O Hub Throttle Registers (rev 13)
00:19.0 Ethernet controller: Intel Corporation 82567V-2 Gigabit Network Connection
00:1a.0 USB Controller: Intel Corporation 82801JI (ICH10 Family) USB UHCI Controller #4
00:1a.1 USB Controller: Intel Corporation 82801JI (ICH10 Family) USB UHCI Controller #5
00:1a.2 USB Controller: Intel Corporation 82801JI (ICH10 Family) USB UHCI Controller #6
00:1a.7 USB Controller: Intel Corporation 82801JI (ICH10 Family) USB2 EHCI Controller #2
00:1b.0 Audio device: Intel Corporation 82801JI (ICH10 Family) HD Audio Controller
00:1c.0 PCI bridge: Intel Corporation 82801JI (ICH10 Family) PCI Express Port 1
00:1c.2 PCI bridge: Intel Corporation 82801JI (ICH10 Family) PCI Express Port 3
00:1c.3 PCI bridge: Intel Corporation 82801JI (ICH10 Family) PCI Express Port 4
00:1d.0 USB Controller: Intel Corporation 82801JI (ICH10 Family) USB UHCI Controller #1
00:1d.1 USB Controller: Intel Corporation 82801JI (ICH10 Family) USB UHCI Controller #2
00:1d.2 USB Controller: Intel Corporation 82801JI (ICH10 Family) USB UHCI Controller #3
00:1d.7 USB Controller: Intel Corporation 82801JI (ICH10 Family) USB2 EHCI Controller #1
00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev 90)
00:1f.0 ISA bridge: Intel Corporation 82801JIR (ICH10R) LPC Interface Controller
00:1f.2 IDE interface: Intel Corporation 82801JI (ICH10 Family) 4 port SATA IDE Controller
00:1f.3 SMBus: Intel Corporation 82801JI (ICH10 Family) SMBus Controller
00:1f.5 IDE interface: Intel Corporation 82801JI (ICH10 Family) 2 port SATA IDE Controller
02:00.0 SATA controller: JMicron Technologies, Inc. 20360/20363 Serial ATA Controller (rev 03)
02:00.1 IDE interface: JMicron Technologies, Inc. 20360/20363 Serial ATA Controller (rev 03)
03:00.0 FireWire (IEEE 1394): VIA Technologies, Inc. Device 3403
06:00.0 VGA compatible controller: nVidia Corporation Device 0a20 (rev a2)
06:00.1 Audio device: nVidia Corporation Device 0be2 (rev a1)
*******************************************
Thanks a lot!!
Re: Fedora12 w/ Amahi install NOT Succeed! Can't get Amahi http
Posted: Sun Mar 14, 2010 9:44 am
by dalorax
I encountered the same problem during installation. However when prompted to 'Enable network interface' I deselected the 'Use dynamic IP configuration (DHCP). It seems as if it was not picking up an IP address from router. U use Linksys WRT310N w/ ddrt v24
Re: Fedora12 w/ Amahi install NOT Succeed! Can't get Amahi http
Posted: Sun Mar 14, 2010 1:55 pm
by coolstone
I encountered the same problem during installation. However when prompted to 'Enable network interface' I deselected the 'Use dynamic IP configuration (DHCP). It seems as if it was not picking up an IP address from router. U use Linksys WRT310N w/ ddrt v24
Change a router?? Just for Amahi? No, it's too ridiculous! Why not choose WHS??
Re: Fedora12 w/ Amahi install NOT Succeed! Can't get Amahi http
Posted: Mon Mar 15, 2010 5:39 am
by dalorax
Sorry for the mistype. I wanted to say "I" instead of "U". Just stating what router I have and use. I assigned a static IP address to the server because it didn't seem to pick one up from the router's dhcp server. Maybe try that before completely giving up.
Re: Fedora12 w/ Amahi install NOT Succeed! Can't get Amahi http
Posted: Mon Apr 05, 2010 8:43 pm
by Mickerik
I encountered the same problem during installation. However when prompted to 'Enable network interface' I deselected the 'Use dynamic IP configuration (DHCP). It seems as if it was not picking up an IP address from router. U use Linksys WRT310N w/ ddrt v24
Why not choose WHS??
WHS isn't a patch on Amahi, plus, it costs money. And, because it uses win 2k3 as a base, it's outdated. It's due an update.