i just have installed amahi for a few days now and i did that on my testbox i have laying around..
The box has 3 network cards installed for various tests and for fun..

Now here the problem i have:
When i installed amahi all 3 cards where present and offcourse eth 0 was the bottem card. Today i have pulled out eth0 as this is a 100 mb card and i would like to test eth 1 which is a 1000mb nic. My thought was if i pull eth0 then eth1 becomes eth0... But the system doesnt think so and now i have a dead amahi box

Who can help me out here??