Amahi Forums

Using the Disk Wizard UI to add a disk, then adding it to the Pool using Greyhole UI.
The disk is shown as correct capacity on the UI, but on command line greyhole -s it shows as a very small fraction of actual size.
Upon rebooting, the drive shows as OFFLINE in greyhole -s, but is still fine in the Greyhole UI.
Any ideas?
Drives were full formated with EXT4. They work fine, just that the info in Greyhole -s is initially incorrect.

Recommend you consult the Greyhole troubleshooting page in the wiki.

BTW, you might check out the troubleshooting page in the wiki before posting in the forums as many problems/solutions are documented there.

Recommend you consult the Greyhole troubleshooting page in the wiki.

BTW, you might check out the troubleshooting page in the wiki before posting in the forums as many problems/solutions are documented there.

I search each time. Even looked in the Bug tracker.
I think this is a bug, rather than a troubleshooting issue. It works, just that the results from the command line don't match the UI.
The /gh is present on the folder.

Ok glad to hear you have found the resources in the wiki.

Request you submit a bug report.

Ok glad to hear you have found the resources in the wiki.

Request you submit a bug report.

I will do that once I can get home and take some screenshots, along with a WIKI entry for getting the HP Proliant GEN8 Microserver singing.