Adding drive to Pool via UI

[evylrat]

Using the Disk Wizard UI to add a disk, then adding it to the Pool using Greyhole UI.
The disk is shown as correct capacity on the UI, but on command line greyhole -s it shows as a very small fraction of actual size.
Upon rebooting, the drive shows as OFFLINE in greyhole -s, but is still fine in the Greyhole UI.
Any ideas?
Drives were full formated with EXT4. They work fine, just that the info in Greyhole -s is initially incorrect.

[bigfoot65]

Recommend you consult the Greyhole troubleshooting page in the wiki.

BTW, you might check out the troubleshooting page in the wiki before posting in the forums as many problems/solutions are documented there.

[evylrat]

Recommend you consult the Greyhole troubleshooting page in the wiki.

BTW, you might check out the troubleshooting page in the wiki before posting in the forums as many problems/solutions are documented there.

I search each time. Even looked in the Bug tracker.
I think this is a bug, rather than a troubleshooting issue. It works, just that the results from the command line don't match the UI.
The /gh is present on the folder.

[bigfoot65]

Ok glad to hear you have found the resources in the wiki.

Request you submit a bug report.

[evylrat]

Ok glad to hear you have found the resources in the wiki.

Request you submit a bug report.

I will do that once I can get home and take some screenshots, along with a WIKI entry for getting the HP Proliant GEN8 Microserver singing.