Re: Amahi 6 Beta, for your testing pleasure!
Posted: Sun Feb 27, 2011 10:20 am
It's been about 9 days since the last activity here - How's the release looking?
The Amahi Home Server Forums
https://forums.amahi.org/
Jason, I too had similar issues when doing my install from scratch, but that was defo to do with the initial setup for the network (my eth0 is dead, so I had to configure and use eth1).Any suggestions? Is the repo down? I assume that it isn't down and that the problem is on my end.
- Jason
hendrixelectric, you're right, the disk stuff should make no difference. On my main install, I didn't do this, as the base drive is a small SSD dedicated to the OS, so I'm not bothered about how that's partitioned for other usage. However, on the VM, I followed all recommendations to the letter. But more than anything, by following those screengrabs, you can see if anything doesn't look right or differs during your install.dinomic,
Thanks for the quick reply and excellent guide! I notice that I missed the Editing the Partitions section, right after Choosing an installation type. I don't think that this is related to my repository error, but I definitely missed that nonetheless. I will walk through these steps and report the results here when I am finished.
Thank you!
hendrixelectric, sorry for the late reply...dinomic,
Everything on my installation looks the same as on the screenshots. Good idea, but still no luck. I followed the instructions verbatim until the "Add Repository" section and can't progress any further. You said you added an interface, eth1, right? That worked for you? You don't have to type a length explanation, but just briefly, what did you do?