I installed Amahi this morning, right after the downtime of the Repos
I just purchased (3 hours ago) the app for Plex one-click installer. After installation, I followed the instructions to run the 'chown' command
but I´m getting this:
http://pastebin.com/aH33SdD9
NOTE: I do not have any GreyHole setup, I ran it because here it says:
Special Instructions NOTE: See wiki guidance for use with Greyhole. If the service does not start properly, execute the following command as root user:
chown -R apache:users /var/lib/plexmediaserver
It should then start within a few minutes.
When I try to access the URL here:
I also ran this coomand
Code: Select all
sudo systemctl restart httpd
I decided to run "systemctl status amahi-plex", the result:
Code: Select all
● amahi-plex.service - Plex Media Server for Amahi
Loaded: loaded (/usr/lib/systemd/system/amahi-plex.service; enabled)
Active: active (running) since Sat 2016-01-30 16:59:14 EST; 1h 36min ago
Process: 845 ExecStart=/usr/bin/amahi-plex (code=exited, status=0/SUCCESS)
Main PID: 849 (runuser)
CGroup: /system.slice/amahi-plex.service
├─ 849 runuser -u apache -g users /usr/lib64/plexmediaserver/Plex ...
├─ 861 /usr/lib64/plexmediaserver/Plex Media Server
├─1124 Plex Plug-in [com.plexapp.system] /usr/lib64/plexmediaserve...
└─1250 /usr/lib64/plexmediaserver/Plex DLNA Server
Jan 30 16:59:14 localhost.localdomain runuser[849]: pam_unix(runuser:session)...
Hint: Some lines were ellipsized, use -l to show in full.
http://ur1.ca/ogpdl -> http://paste.fedoraproject.org/316707/19701414
Thanks, this is my first time with Linux in General, but you guides are very clear!.