CLOSED: New Installation
Posted: Mon Nov 15, 2021 1:00 pm
Hi, I installed Amahi.
Initially after the server installed and I rebooted I could not connect to any webpage ending in anything other than .com. I could not connect to the server using http://hda/ or the HDA IP I was given when setting up my account. To regain full Internet access I had to turn off the server and reset the router. The server did install and tell me to reboot.
When instructed to input the following commands:
rpm -Uvh http://f27.amahi.org/noarch/hda-release ... noarch.rpm
dnf -y install hda-ctl
hda-install -i YOUR-INSTALL-CODE
There was a lot of info scrolling down the screen after each command. I missed the display of the IP address. When the server starts up it is in command prompt. When inputting ifconfig, it returns with: "command not found." Caps were not on. I tried several times paying close attention to my typing. It was entered correctly.
Going to http://hda/ brings up this page https://i.imgur.com/VgsZkVA.png
When I enter the name and password that I set as login to the server I get an, "Unable to connect" error message. I am able to login to the server so I know what the login ifno is. If I attempt to set a new password I get the same Unable to connect message.
So, what am I doing wrong?
Initially after the server installed and I rebooted I could not connect to any webpage ending in anything other than .com. I could not connect to the server using http://hda/ or the HDA IP I was given when setting up my account. To regain full Internet access I had to turn off the server and reset the router. The server did install and tell me to reboot.
When instructed to input the following commands:
rpm -Uvh http://f27.amahi.org/noarch/hda-release ... noarch.rpm
dnf -y install hda-ctl
hda-install -i YOUR-INSTALL-CODE
There was a lot of info scrolling down the screen after each command. I missed the display of the IP address. When the server starts up it is in command prompt. When inputting ifconfig, it returns with: "command not found." Caps were not on. I tried several times paying close attention to my typing. It was entered correctly.
Going to http://hda/ brings up this page https://i.imgur.com/VgsZkVA.png
When I enter the name and password that I set as login to the server I get an, "Unable to connect" error message. I am able to login to the server so I know what the login ifno is. If I attempt to set a new password I get the same Unable to connect message.
So, what am I doing wrong?