Hi All,
I am stuck a little bit following the manual instructions to add a second hard drive.
My box, already had 2 X 2 TB hard drives installed. I can see the drives listed under the drives section in my HDA, but during installation, I had only selected one of the drives to install the software on as per the instructions.
Now, I am trying to add the second hard drive, and I followed the instructions precisely. I am stuck at this step nano /etc/fstab.
When I run this command I get
Ignoring /dev/sdb1 - already in /etc/fstab as UUID=
The manual steps asks me to take a note of the UUID and add it to /etc/fstab, but the UUID is blank and it is already in /etc/fstab. The notable difference is that /dev/sda1 & /dev/sda3 have UUID's listed.
I cannot move to the next step. Stuck here. Please suggest. Thanks in advance.
Adding a second hard drive - manual instructions
-
- Posts: 3
- Joined: Thu Oct 15, 2020 5:33 pm
Re: Adding a second hard drive - manual instructions
It sounds like the drive already exists. Run this command and share the output:
Code: Select all
cat /etc/fstab
Re: Adding a second hard drive - manual instructions
If you did not deselect the drive when installing Fedora, it's already mounted most likely.
You may need to unmount it before mounting it in the location you desire.
You may need to unmount it before mounting it in the location you desire.
ßîgƒσστ65
Applications Manager
My HDA: Intel(R) Core(TM) i5-3570K CPU @ 3.40GHz on MSI board, 16GB RAM, 1TBx1+2TBx2+4TBx2
Applications Manager
My HDA: Intel(R) Core(TM) i5-3570K CPU @ 3.40GHz on MSI board, 16GB RAM, 1TBx1+2TBx2+4TBx2
Who is online
Users browsing this forum: No registered users and 3 guests