Amahi Forums

Hello everyone, I am following the installation directions using this: https://wiki.amahi.org/index.php/Amahi_11_Install

I get to the end where I have to type in some code. I type in the code, but I keep getting an error.

I type in the code exactly as it is shown and I get hda-ctl not found which basically prevents me from doing the hda-install -i R7HWATC

Any advice?
https://imgur.com/a/NwRdgYB



Thanks in advance!

Did you set up your profile on amahi.org? That's where you get the install code.

I cannot see your image, but it could be a few different things.

Have you followed the instructions precisely, not deviating?

Yes, I set it up online. I have followed the instructions to the dot and can’t figure this out.

Can you not see the link I posted to the image?

I cannot see the image because it's blocked at my work.

Will have to look when I get home.

I cannot see the image because it's blocked at my work.

Will have to look when I get home.

Thank you I appreciate that.

The first command did not execute, which is the root cause of your difficulties. That command installs packages you’ll need for the next two commands.

Ensure you type each command in correctly and don’t preceed until each is successful.

I am going to reinstall this and will try again. If it doesn't work I have no idea why. The command is typed in correctly you can see that.

Ok.

Did you copy and paste or type manually.

If it was typed in correctly you would not have gotten that output.

Something was not right or maybe there was connectivity issues with your machine.

I am doing this form USB that should not be a problem correct?