New install complete - How to RAID drives
Posted: Sat Feb 07, 2015 2:00 pm
Finally got Amahi installed and running. The control panel shows it's running and I can log in to the HDA interface.
In the HDA under SETUP > Disks I can see the 5 disks in the box:
1- Boot SSD (installation here)
2- 3T HD
3- 3T HD
4- 3T HD
5- 3T HD
Now that everything seems to be running well before I add users or data to the server I'd like to RAID-5 or RAID-10 the drives but do not see a way to do this.
I tried to use the hardware RAID controller that the drives are connected to but the HDA sees each drive independently anyway!
I assume I'll need to install an app to do this then but the only one that comes up again and again is Greyhole, which is not really a RAID controller... Or is it?
Thx
RG
In the HDA under SETUP > Disks I can see the 5 disks in the box:
1- Boot SSD (installation here)
2- 3T HD
3- 3T HD
4- 3T HD
5- 3T HD
Now that everything seems to be running well before I add users or data to the server I'd like to RAID-5 or RAID-10 the drives but do not see a way to do this.
I tried to use the hardware RAID controller that the drives are connected to but the HDA sees each drive independently anyway!
I assume I'll need to install an app to do this then but the only one that comes up again and again is Greyhole, which is not really a RAID controller... Or is it?
Thx
RG
