Page 1 of 1

Can't access the internet

Posted: Mon Jul 20, 2009 1:41 pm
by avica
Hello
I made a mistake with the Modem Getway and I understend that I have to reinstall Amahi.
I did delete the profile and created a new and hopfuly correct one.
The problem is that running:

Code: Select all

hda-install -f KEYCODE
I get a massage that says stopping monit failed and later when it try to get profile it fails accessing the web.

what am I doing wrong?

Re: Can't access the internet

Posted: Mon Jul 20, 2009 1:48 pm
by moredruid
probably you forgot to turn DHCP on your router back on.
failing that, your hda is probably stuck with a fixed IP in the wrong range. You can try to run "dhclient eth0" on the command line (terminal). Not sure if this works though. I know there's a way to uninstall amahi, thus releasing the IP settings as well, but I forgot what the command was.

Re: Can't access the internet

Posted: Mon Jul 20, 2009 2:12 pm
by bsk
Go into your router (if you can) and turn DHCP Server back ON, then reboot your hda, when on do:

Code: Select all

hda-install -f CODE
And then restart again after that has completed, let your hda boot up, turn DHCP Server back OFF on your router and reboot your hda once more.


If you cannot get to your router, do a hard reset on it so set it back to factory settings, and then start from there.

What I like to do is, set it up like I would have it set up WITHOUT Amahi and save (backup) the configuration, that way its easy to go back if needed.